
|
Model
A-50 Specifications |
 |
Fat or Oil Capacity of bowl is 50 lbs. |
 |
Overall Height is 13 1/4" to fit under most fryer drains. |
 |
Overall Length is 24 1/2" |
 |
Overall Width is 17 1/2" |
 |
Removable, easy to clean, tin dipped steel bowl, 15 7/8"
diameter, 9 1/2" deep. |
 |
Gear Type - positive displacement suction pump, vacuum
equivalent 22" mercury at 1,725 RPM, delivering plus 3.5 GPM of filtered fat at 350°
F. |
 |
Covered 1/4 HP, 1,725 RPM, single phase motor, 110/120 volts
AC, direct connected to pump through flexible coupling. |
 |
Heat resistant 1/2" ID output hose provided with cold
wood handle and No-Splash Nozzle. |
 |
Filter mounted on 3" ball bearing, oil resistant casters. |
 |
Removable push-pull handle for easy maneuvering. |
 |
Shipping weight is 100 lbs. |
|
| |
Operation is Easy |
 |
Heat used fat or oil in fryer to at least 360° F. |
 |
Move filter under fryer drain. |
 |
Open drain, letting heated fat flow into filter bowl. |
 |
After nozzle of hose is placed in fryer, switch on motor and
wash down sides with hot fat (this fat flows back into filtered bowl for purification). |
 |
Close drain and continue pumping filtered fat back into fryer
until filter bed is dry and stream from nozzle has stopped completely. |
 |
Switch off motor, disconnect hose for draining and lift out
weighted ring and bottom screens along with accumulated debris and used filter bed. |
| |
|
|
|